Removal and installation steps of hot oil pump

Category: Water pump knowledge

2024-09-02

The removal and installation steps of the hot oil pump are the key processes to ensure the normal operation and maintenance of the equipment. The following are the detailed removal and installation steps.

1. hot oil pump disassembly steps:

1. Turn off the power supply of the pump and related systems to ensure that there is no voltage.

2. Remove the inlet and outlet pipes of the hot oil pump and place them properly to prevent damage.

3. Remove the cable connected to the pump and record the connection method and identification.

4. Remove the bolts on the bearing housing cover and remove the bearing housing cover.

5. Remove the bolts connecting the bearing box and the pump body, and separate the bearing box from the pump body.

6. Remove the bearing gland bolts and take out the bearing gland and bearing.

7. Remove the sealing device and perform the corresponding operation according to the sealing type.

8. Disassemble the impeller, taking care to avoid damaging the blades and hub.

9. Inspect internal parts and record wear and damage.

2. hot oil pump installation steps:

1. Clean the installation site to ensure that the work area is clean.

2. Place the hot oil pump on the foundation to ensure the level.

3. Install the bearing box and bearing to ensure that the bearing position is correct.

4. Install the impeller and check whether the rotation direction is correct.

5. Install the sealing device to ensure good sealing performance.

6. Install the bearing gland and bolts, and tighten the gland bolts.

7. Install the connecting bolts between the pump body and the bearing housing and ensure that they are fastened.

8. Install the bearing housing cover and bolts to ensure that the sealing gasket is intact.

9. Connect the cable and wire it according to the recorded recovery connection method.

10. Install the inlet and outlet pipes to ensure that the pipes are not blocked or leaked.

11. Start the pump for trial operation and check for abnormal sound, vibration or leakage.

Note:

1. During the operation, ensure that the staff follow the safety operation procedures.

2. Use appropriate tools for disassembly and installation to avoid damage to parts.

3. During disassembly and installation, keep the parts clean and avoid impurities from entering the pump.

4. When disassembling and installing, pay attention to record and check the wear and damage of the parts for necessary maintenance or replacement.

5. After the installation is completed, conduct a trial run to ensure the normal operation of the hot oil pump.

Following the above steps, the hot oil pump can be removed and installed correctly and safely. Pay attention to details and safety during operation to ensure the normal operation of the equipment and extend its service life.

Previous: Faults and Solutions of Hot Oil Pump

Next: How to repair and maintain the hot oil pump

Contact Us

Free Hotline:+86 18142662779

Fixed telephone:+86 19313001794      

Mobile:+86 18142662779(WeChat/WhatsAPP)

E-mail:info@sanchangpump.net