Faults and Solutions of Hot Oil Pump

Category: Water pump knowledge

2024-09-02

Hot oil pump is a common industrial equipment, widely used in petroleum, chemical, electric power and other fields. However, due to long-term operation, improper operation or equipment aging, the hot oil pump may have various failures. The following are some common hot oil pump failures and their solutions.

1. fault phenomenon:

1. Insufficient flow: When the hot oil pump is running, the flow is unstable and may be lower than expected.

2. Noise and vibration: There is a lot of noise and vibration when the equipment is running.

3. The temperature is too high: the temperature of the hot oil pump and its surrounding equipment is too high.

4. Leakage: Leakage at the seal or flange connection.

2. fault reason:

1. Insufficient flow may be caused by insufficient suction pressure, pipeline blockage, or insufficient pump speed.

2. Noise and vibration may be caused by bearing wear, imbalance or misalignment.

3. Excessive temperature may be caused by overload operation, cooling system failure or bearing damage.

4. Leakage may be caused by aging seals, loose fastening bolts or improper installation.

3. solutions:

1. For the problem of insufficient flow, the suction pressure of the pump, the smoothness of the pipeline and the pump speed should be checked to ensure that the equipment operates within the specified parameters.

2. For noise and vibration problems, check the condition of the bearing, make balance and alignment adjustments, and replace the bearing if necessary.

3. In view of the excessive temperature, check the load condition to ensure that the equipment is not overloaded; check the cooling system to ensure its normal operation; check the lubrication condition of the bearing, and add or replace the lubricating oil in time.

4. For leakage problems, check the condition of the seals and replace the aging or damaged seals in time; check the fastening bolts to ensure that they are fastened and reliable; ensure correct installation.

4. precautions:

1. Regularly inspect and maintain the hot oil pump to ensure that the equipment is in good condition.

2. Regularly check the flow, pressure, temperature and other parameters of the pump to ensure that it meets the requirements.

3. Keep the equipment clean and avoid impurities entering the pump.

4. Select the appropriate lubricating oil to ensure that the bearing is well lubricated.

In short, the failure of the hot oil pump involves many aspects, and factors such as equipment status, operating environment, operation and maintenance need to be considered comprehensively. In practical application, the cause of failure should be analyzed according to the specific situation and corresponding solutions should be taken. At the same time, regular equipment inspection and maintenance are carried out to prevent the occurrence of failures.

Previous: The working principle and structure of hot oil pump

Next: Removal and installation steps of hot oil pump

Contact Us

Free Hotline:+86 18142662779

Fixed telephone:+86 19313001794      

Mobile:+86 18142662779(WeChat/WhatsAPP)

E-mail:info@sanchangpump.net