How to use a submersible pump

Category: Water pump knowledge

2024-11-26

Submersible PumpIt is a device commonly used for transporting liquid media, widely applied in chemical, pharmaceutical, environmental protection, and other fields. To ensure the normal operation of the submersible pump and extend its service life, it is crucial to use the submersible pump correctly. Below is the usage guide for the submersible pump.

I. Preparation Before Operation

1. Check whether the submersible pump and its accessories are intact and whether the screws are loose.

2. Confirm that the power connection is normal and the voltage is stable.

3. Ensure that the installation position of the pump is higher than the liquid medium to prevent backflow.

II. Startup Steps

1. Open the inlet valve to allow liquid to enter the pump chamber.

2. Press the start button to make the submersible pump begin to operate.

3. Observe the operation of the pump to confirm there are no abnormal sounds or vibrations.

4. Slowly adjust the outlet valve to achieve the desired flow rate.

III. Precautions During Operation

1. Regularly check the bearing temperature and vibration of the submersible pump. If abnormalities are found, stop the machine for inspection.

2. Regularly check the sealing performance of the pump. If leaks are found, replace the sealing components in a timely manner.

3. Ensure that the inlet and outlet valves of the pump are opened appropriately to avoid being too large or too small.

4. Avoid running the pump without load to prevent damage to the internal components.

IV. Shutdown Steps

1. Slowly close the outlet valve to reduce the flow rate.

2. Press the stop button to make the submersible pump stop operating.

3. Close the inlet valve to prevent backflow of liquid.

4. Disconnect the power supply to ensure safety.

V. Maintenance and Care

1. Regularly clean the submersible pump to keep its appearance tidy.

2. Regularly check the internal components of the pump. If there is severe wear, replace them in a timely manner.

3. Regularly check the fasteners of the pump. If they are loose, tighten them in a timely manner.

4. Replace the lubricating oil regularly as recommended by the manufacturer.

VI. Safety Precautions

1. When operating the submersible pump, comply with relevant safety operating procedures.

2. Avoid performing maintenance work while the submersible pump is running to prevent accidents.

3. Ensure that the submersible pump is well grounded to prevent electric shock.

4. Avoid using inappropriate tools or chemicals to prevent damage or safety hazards.

In summary, correct use of the submersible pump requires following guidance on preparation before operation, startup steps, precautions during operation, shutdown steps, maintenance and care, and safety precautions. Only by using and maintaining the submersible pump correctly can its normal operation be ensured and its service life extended.

Previous: What material should be used to make submersible pumps?

Next: Factors Affecting the Cavitation Margin of Submersible Pumps and Solutions

Contact Us

Free Hotline:0086-13307481676

Fixed telephone:0086-13307481676      

Mobile:0086-13307481676(WeChat)

E-mail:sales@sanchangpump.com