Removal and Installation of Horizontal Centrifugal Pump

Category: Water pump knowledge

2024-08-22

horizontal centrifugal pumpThe removal and installation steps are an important part of ensuring the normal operation and maintenance of the equipment, which is described in detail below.

1. removal steps

1. Preparation: Turn off the power and ensure that the pump has stopped running. Prepare the necessary tools, such as wrenches, screwdrivers, etc.

2. Disassemble the inlet and outlet pipes: first loosen the fixing bolts, and then remove the inlet and outlet pipes.

3. Remove the bearing housing cover: Use a special tool or wrench to remove the fixing bolts on the bearing housing cover.

4. Take out the rotor: gently shake the shaft to confirm that there is no liquid in the pump, and then use a special tool to take out the rotor.

5. Disassemble the bearing and bearing box: Remove the fixed parts on the bearing and bearing box one by one.

6. Remove the sealing device: according to the seal type, follow the corresponding removal steps.

7. Check the internal parts: check the parts of the pump for wear, corrosion or damage, and record it.

2. installation steps

1. Preparation: Make sure that all the disassembled parts have been cleaned, and check whether the new parts meet the requirements.

2. Install the bearing and bearing box: Install the bearing and bearing box on the pump body and fix it.

3. Install the rotor: Gently put the rotor into the pump body to ensure the correct position.

4. Install the bearing case cover: Install the bearing case cover on the pump body and fix it with special tools.

5. Install the sealing device: install the sealing device correctly according to the corresponding installation steps.

6. Install the inlet and outlet pipes: connect the inlet and outlet pipes with the pump, and fix the bolts.

7. Inspection and test: Check whether all parts are installed correctly, then start the pump for trial operation, and check whether there is abnormal sound or leakage.

8. Maintenance: regular maintenance of the pump, check the use of bearings, sealing devices and other wearing parts, timely replacement of damaged parts.

Precautions

1. During disassembly and installation, pay attention to protect all parts of the pump to avoid damage or scratches.

2. When disassembling and installing, follow the corresponding operating procedures and safety regulations to ensure the safety of personnel.

3. After the installation is completed, a trial operation inspection shall be carried out to ensure the normal operation of the pump.

The above is the horizontal centrifugal pump removal and installation steps. Correct disassembly and installation can ensure the normal operation of the pump and extend its service life. When operating, be sure to follow the appropriate procedures and safety specifications to ensure the safety of personnel and equipment.

Previous: Fault and Solution of Horizontal Centrifugal Pump

Next: Horizontal centrifugal pump how to repair and maintenance

Contact Us

Free Hotline:+86 18142662779

Fixed telephone:+86 19313001794      

Mobile:+86 18142662779(WeChat/WhatsAPP)

E-mail:info@sanchangpump.net