The Fault and Solution of Centrifugal Pump

Category: Water pump knowledge

2024-08-07

Centrifugal pumpIt is a common fluid conveying equipment and is widely used in various fields. However, during use, due to various reasons, centrifugal pumps may have some failures. The following will introduce the common centrifugal pump fault and its solution.

1. common centrifugal pump failures

1. Insufficient flow: This may be caused by insufficient pump speed, impeller damage or pipeline blockage.

2. Noise and vibration: may be due to the imbalance of the pump, bearing wear, foreign matter into the pump or poor pipeline support and other reasons.

3. Leakage: aging seals, shaft seal damage or flange connection is not tight, etc. may lead to leakage of the centrifugal pump.

4. Motor overload: it may be caused by increased friction in the pump, foreign body jamming in the pump or motor failure.

5. Unable to start: it may be caused by power supply problems, motor failure or stuck in the pump.

6. Cavitation: This happens when the pressure in the pump body drops below the vapor pressure of the liquid, thereby forming bubbles. These bubbles can then collapse, damaging the impeller and reducing the efficiency of the pump.

2. Solution

1. For the problem of insufficient flow, you can check whether the pump speed meets the requirements, and check whether the impeller is damaged or blocked. If there is a problem, adjust the speed, replace the impeller or clean the blockage.

2. For noise and vibration problems, it is necessary to check whether the pump is balanced and whether the bearings are worn. If there is a problem, it is necessary to adjust the balance, replace the bearing or clean up the foreign matter in the pump.

3. For leakage problems, it is necessary to check whether the seal and shaft seal are intact and whether the flange connection is tight. If there is a problem, replace the seal, shaft seal or re-tighten the flange connection.

4. For the motor overload problem, it is necessary to check the friction and foreign matter in the pump and whether the motor is normal. If there is a problem, clean the pump, reduce friction or replace the motor.

5. For the problem of unable to start, it is necessary to check whether the power supply and motor are normal, and whether the pump is stuck. If there is a problem, check the power supply, repair the motor fault or clean the jam in the pump.

The solution to this problem of cavitation is to increase the pressure in the suction line or to reduce the speed of the pump.

Centrifugal pump is a common industrial pump, but there will be various failures in use. In normal work, we should also pay attention to strengthening maintenance, and check the operation of the pump regularly to prepare for prevention.

In addition to the above solutions, it is necessary to pay attention to the maintenance and maintenance of the centrifugal pump in daily use, such as regular replacement of lubricating oil and inspection of bearing wear. In short, the correct use and maintenance of centrifugal pumps can effectively reduce the probability of failure and extend the service life of the pump. If you have more technical questions, it is recommended to consult a professional.

Previous: The working principle and structure of centrifugal pump

Next: Removal and Installation of Centrifugal Pump

Contact Us

Free Hotline:+86 18142662779

Fixed telephone:+86 19313001794      

Mobile:+86 18142662779(WeChat/WhatsAPP)

E-mail:info@sanchangpump.net