Failure of oil pump and its solution

Category: Water pump knowledge

2024-07-26

Oil pumpIt is a key component in many mechanical equipment and is used to provide the necessary pressure and flow to ensure the normal operation of the system. However, due to long-term use or other factors, various failures of the oil pump may occur. The following will introduce some common oil pump failures and their solutions.

The maintenance and maintenance of the oil pump in the engine has an important impact on the normal operation and service life of the vehicle. Regular inspection and timely handling of various failures of the oil pump can ensure the stability and safety of the vehicle.

Common faults of 1. oil pump

1. Noise and vibration: Abnormal noise and vibration are generated when the oil pump is running, which may be caused by internal parts wear, cavitation or external interference.

2. Insufficient pressure: The pressure output by the oil pump is lower than the set value, which may cause the system to fail to work normally.

3. Leakage: aging, damage or improper installation of seals may cause oil pump leakage.

4. Unstable performance: The output flow of the oil pump is unstable, which may affect the operation of the entire system.

2. Solution

1. Noise and vibration treatment: first check whether the installation of the oil pump is stable, if necessary, can be tightened. The drive parts are then checked for alignment, which may cause vibration. Finally, check whether the internal parts of the oil pump, such as gears and bearings, are worn, and replace them if necessary. If the oil pump noise becomes irregular and the hiss increases, it usually means that the inlet or outlet of the oil pump is blocked. If the noise is getting louder and louder, it may mean that there is a lack of oil, so the problem needs to be checked and dealt with immediately. If the noise of the oil pump continues to increase, it means that the pump body or components may be damaged, and the oil pump or its components need to be replaced.

2. Treatment of insufficient pressure: first check whether the oil inlet of the oil pump is blocked or restricted to ensure that the oil source is sufficient. Then check that the pressure regulating valve is set correctly and adjust if necessary. Finally, check the sealing performance inside the oil pump to ensure that there is no internal leakage. Engine flameout, jitter, etc. may be caused by low fuel pressure. Check whether the fuel pump is working. If it is working properly, check whether the fuel supply pipeline is blocked or leaking. If it is normal, check whether the fuel pump pressure is normal. If the fuel pressure is normal, check the fuel delivery pipe or nozzle for blockage. If there is a blockage, clean or replace the relevant parts. Check the power supply line of the oil pump, especially whether the joint is in normal contact and whether the power supply is stable. If the power supply is normal and the oil pump still cannot work, check whether the oil pump is damaged or aged.

3. Leakage treatment: first check the status of the seals, such as O-rings, gaskets, etc., if damaged or aging should be replaced in time. Then check whether the connection part is tight, if loose should be tightened. For other types of leaks, a deeper overhaul may be required.

4. Treatment of unstable performance: First check the quality and cleanliness of the oil. Unclean oil may cause unstable oil pump performance. Then check the internal parts of the oil pump, such as pump blades, rotors, etc., for wear or damage, and replace them if necessary. Finally, check whether the control system is working properly.

In order to prevent the oil pump from malfunctioning, it is recommended to carry out regular maintenance and inspection to ensure that the oil pump is in good working condition. In addition, using the correct oil type and maintaining the cleanliness of the oil are also key to preventing failures. If the above methods cannot solve the problem, it is recommended to seek the help of a professional technician.

Previous: Working principle and structure of oil pump

Next: Removal and installation steps of oil pump

Contact Us

Free Hotline:+86 18142662779

Fixed telephone:+86 19313001794      

Mobile:+86 18142662779(WeChat/WhatsAPP)

E-mail:info@sanchangpump.net