Removal and installation steps of oilfield water injection pump

Category: News

2024-07-20

Oil field water injection pumpThe removal and installation steps are an important part of oilfield operations. The correct operation process and technical means can ensure the safe disassembly and accurate installation of the equipment, and improve the working efficiency and service life of the oilfield water injection pump. The following describes the general removal and installation steps to help operators better work.

1. removal steps

1. Preliminary preparation: ensure that the power supply has been disconnected, the pressure in the pump has been completely released, and necessary cleaning work has been carried out. Prepare appropriate tools, such as wrenches, screwdrivers, etc.

2. Remove the shell: Use a tool to remove the external fixing screws of the pump and remove the shell.

3. Remove the bearing: the bearing is usually detachable, use a special tool to loosen the bearing.

4. Disassemble the impeller and shaft seal: gently rotate the impeller and remove it from the shaft after confirming that there is no obstruction. Special care should be taken to avoid damaging the seal face.

5. Check the internal parts: check the internal parts of the pump, such as rotors, bearings, impellers, etc., for wear or damage. Remove motor for water injection pump. Remove the housing of the motor first, and then untie the connecting bolt between the motor and the pump body. Note that when disassembling the motor, handle it carefully to avoid damage.

6. Remove the sealing device and other accessories: according to the specific situation, remove other parts such as sealing device, pressure sensor, etc.

2. installation steps

1. Pre-preparation: Ensure that all parts are cleaned and check for damage or wear. Prepare the necessary tools and installation materials. Determine the installation location and ensure that the foundation is firm and flat. Then, connect the pump body to the motor, fix the two with connecting bolts, and ensure that the fastening is strong.

2. Install the bearing and impeller: first install the bearing to ensure that the bearing position is correct and fixed firmly. Then install the impeller, ensuring that the impeller fits tightly with the shaft.

3. Install the shaft seal: When installing the shaft seal, ensure that the sealing surface is clean and the seal is installed correctly to avoid leakage.

4. Install the shell: Place the shell on the pump body and make sure that all screw holes are aligned, and then fix the screws.

5. Install the sealing device and other accessories: install other parts in the reverse order of disassembly, such as sealing device, pressure sensor, etc.

6. Check and test: After the installation is completed, check whether the pump is installed correctly, and then conduct a trial run to ensure that the pump runs normally and there is no leakage. Check and debug the system, turn on the power, check the operation and flow of the water injection pump. If any abnormality is found, eliminate the problem in time until the equipment runs normally.

7. Maintenance: regular maintenance, check the operation of the pump, if found abnormal should be handled in time. Regularly clean and lubricate the pump to ensure long-term stable operation of the pump.

Note:

1. In the process of operation, be sure to follow the safety operation procedures to ensure personal safety.

2. During disassembly and installation, pay attention to protect the parts of the pump to avoid damage.

3. For uncertain parts or difficult to operate steps, it is recommended to consult professionals or manufacturers.

Through the above removal and installation steps, the normal operation of the oilfield water injection pump can be guaranteed. However, it is necessary to pay attention to safety during the operation and operate in strict accordance with the operating procedures. Only correct and meticulous operation can ensure the safe and efficient operation of the equipment and improve the efficiency of oilfield production. Correct operation can ensure the normal operation of the pump and extend its service life.

Previous: What to do when a high corrosion and wear resistant multistage pump does not suck water

Next: No more!

Contact Us

Free Hotline:+86 18142662779

Fixed telephone:+86 19313001794      

Mobile:+86 18142662779(WeChat/WhatsAPP)

E-mail:info@sanchangpump.net